- Remove negative cable (-) of battery to prevent short circuit.
- Yellow & black/green wire of relay harness into an existing grommet on firewall and pull it inside vehicle
- Install relay in the engine bay with supplied screw & washer.
- Connect wire of switch connection to wire that is pulled on 2.
- Install black/yellow harness that is from switch connection side with existing harness of back-up lamp.
- Install yellow harness (w/15A fuse) that is from relay with battery positive (+).
- Connect harness to IPF back-up lamp.
- Secure all cables with cable ties.
- After installation check for correct wiring and connect the negative (-) terminal of battery.
|
